gfd

Garlin, just wanted to say thanks again

That was going to be my original answer, but wasn't sure if the CR/LF was going to be a problem. Since UNIX/Linux-based devices (like...

It's probably annoyed you "hung up" the connection. I believe there's an "-i [key file]"

This also worked ( echo enable echo config echo interface ten-gigabitEthernet 1/0/4 echo power inline supply disable echo end echo exit...

While you could feed a sequence of ECHO lines piped through plink, just use plink's command-line options. @echo off plink.exe -ssh...

Hi garlin, This worked! Thank you so much. The routine ran and the device attached to port 4 turned on. Adding the command file did the...

I'm guessing this is a Cisco device, which is finicky about CR/LF? There's an extra line after the last "exit", but this forum software...

Thanks again garlin, I am a bit embarrassed. I didn't bother listing the model. It is a TP-Link switch. TL-SX3602HPP. My apologies

Thanks Garlin, I can't get past the first request for a carriage return. There are seven additional carriage returns. Any idea how I...

Greetings, I am trying to write a batch file which will use SSH to connect with a managed switch. Once connected, I would like to turn...