Need help setting up Wavlink ax3000 and ac1200 access point

Wavlink ax3000 and ac1200 access point and router
Hello im trying to setup this equipment and need some guidance please.
Im taking a ethernet cable from my modem in my home to the AX3000 on my roof
Then on my other building line of site, i have installed the ac1200 access point which has a etherent cable that goes into the building hooked into a wireless router.

My main question is the ax3000 and the ac1200 have many different possible ways they can be used and im not sure which ones to select in there setups.
I can connect to the ax3000 right now and have internet, but when i try and connect to the wireless modem in the other buiding i get nothing, the red light is blinking on the router tied to the ac1200.

Both of these units use poe and they are powered up.



im sure it will be simple for someone who has done this

thanks in advance for helping me!



Mack

I'd recommend taking your inquiry to SmallNetBuilder.com, where the community is completely network focused.
You should find the following interesting, and perhaps helpful:

The “Wireless How To” section
This covers AP mode, roaming, channel selection, and mixed‑mode networks.


2. Router/AP mode explanations
Wavlink’s UI can be confusing; SNB’s guides clarify the underlying concepts.


3. Wi‑Fi 6 (AX) tuning advice
Even if the model isn’t reviewed, the AX behavior is universal.


4. Forums with people who’ve used Wavlink, Tenda, TP‑Link, etc.
Budget‑tier hardware users often congregate there.

HTH,
--Ed--

thank you