Windows 11 PC with Touchscreen

Hi All,
I have a Windows 11 PC fitted with a touchscreen. I am using an application that uses the touch input to adjust a ramp function, When holding and using the right mouse button the control does ramp correctly, but if i try to touch and hold the onscreen button it won't do it, it will only act as a short touch control for ON/OFF not ramping from ON to OFF and visa-versa. What controls do i need to change/adjust to allow this to happen correctly.

AI says:
To adjust the touchscreen settings on a Shuttle PC, open the eGalaxy Touch tool, go to the "Display" tab, and ensure the correct monitor is selected. You may also need to perform a calibration by clicking on the "Tools" tab and selecting "4 Points Calibration."
Touchscreen Setup for Shuttle PCs

Initial Setup​

1. Install Drivers: Begin by installing the eGalax Touch Panel Driver. This driver is essential for touchscreen functionality and can be found on the Shuttle support website.
2. Access Touch Panel Utility: After installation, locate the eGalax Touch utility in the Start Menu under Programs.

Calibration Process​

To ensure accurate touch response, calibration is necessary:

1. Open Calibration Tool: In the eGalax Touch utility, navigate to the "Tools" tab and select the "4 Points Calibration" option.
2. Follow Calibration Steps: The calibration utility will guide you through the process. You will need to touch specific points on the screen as prompted.
3. Completion Confirmation: Once all points are calibrated, a confirmation dialog will appear, indicating that the touchscreen is ready for use.

Display Settings​

To set the touchscreen as the main display:

1. Open Display Tab: In the eGalax Touch utility, go to the "Display" tab.
2. Enable Settings: Check the options for "Enable Multiple Monitors" and "Map to main display if system has only one display monitor."
3. Recalibrate: After applying these settings, you will be prompted to recalibrate the touchscreen. Follow the calibration steps again to finalize the setup.

Troubleshooting Tips​

• Check Speaker Foil: If sound is poor, ensure that the transparent protection foil on the speakers is removed.
• Resolution Settings: For extended mode, ensure the resolution is set to 800x480 for the touch panel.

By following these steps, you can effectively set up and calibrate the touchscreen on your Shuttle PC

Touchscreen Setup for Shuttle PCs​

Initial Setup​

1. Install Drivers: Begin by installing the eGalax Touch Panel Driver. This driver is essential for touchscreen functionality and can be found on the Shuttle support website.
2. Access Touch Panel Utility: After installation, locate the eGalax Touch utility in the Start Menu under Programs.

Calibration Process​

To ensure accurate touch response, calibration is necessary:

1. Open Calibration Tool: In the eGalax Touch utility, navigate to the "Tools" tab and select the "4 Points Calibration" option.
2. Follow Calibration Steps: The calibration utility will guide you through the process. You will need to touch specific points on the screen as prompted.
3. Completion Confirmation: Once all points are calibrated, a confirmation dialog will appear, indicating that the touchscreen is ready for use.

Display Settings​

To set the touchscreen as the main display:

1. Open Display Tab: In the eGalax Touch utility, go to the "Display" tab.
2. Enable Settings: Check the options for "Enable Multiple Monitors" and "Map to main display if system has only one display monitor."
3. Recalibrate: After applying these settings, you will be prompted to recalibrate the touchscreen. Follow the calibration steps again to finalize the setup.

Troubleshooting Tips​

• Check Speaker Foil: If sound is poor, ensure that the transparent protection foil on the speakers is removed.
• Resolution Settings: For extended mode, ensure the resolution is set to 800x480 for the touch panel.

By following these steps, you can effectively set up and calibrate the touchscreen on your Shuttle PC