Game freezes and crashes with glitched BSOD

Since about last week I've been getting crashes when I play games.
Loading into Battlefield 2042 causes my PC to crash.
Playing Cyberpunk 2077 causes the same.
The worst part is my BSOD is glitched. I've bought new Ram going from 16GB 3200MHz to 32GB 3600MHz and the issue persists. The reason I've bought new ram was because MEMTEST86 found some errors on my old RAM. Buying a new set has improved the crashing overall before I couldn't even load into Cyberpunk it would crash on launch. Now it loads into game then crashes after a few minutes. When it crashes it freezes the game and a second of audio repeats, sometimes it will show the glitched BSOD see the attached image. Before I ran FurMark and it ran fine for about 5 minutes then crashed to the glitched BSOD. I've rolled back my BIOS reinstalled windows done SFC /scannow a few times. Replaced the RAM tried without the XMP profile. Ran CHKDSK. I can run less intensive games fine.

Sometimes it will crash to the desktop with the error "The required data was not placed into memory because of an I/O error status of 0x000000e."

Here is a link to my log: V2 Log File
Attached is my BSOD it hangs and doesn't create a dump file there are a couple of old dump files.
Any help would be appreciated.

Have you run MemTest86 again with your new set of RAM? You need to run the program for at least 8 passes (two runs of 4 passes).

I would also suggest looking at updating the Logitech G Hub software if you're able to, it is known to cause issues otherwise I would suggest removing it completely.

Please perform the following steps:


1) Run Tuneup plus > post a share link into this thread





2) Run Sea Tools Long Generic test (all drives)




3) Run HD Tune (free or trial version) (all drives)
Post share links for results on these tabs:
a) Health
b) Benchmark
c) Full error scan



4) Open administrative command prompt and copy and paste: chkdsk /b /v C:

Run these chkdsk switches on all drives using the syntax: chkdsk /b /v C: or chkdsk /b /v D: or chkdsk /b /v E: etc.


Run these chkdsk switches overnight while sleeping.

C:\WINDOWS\system32>chkdsk /b /v c:
The type of the file system is NTFS.
Cannot lock current drive.

Chkdsk cannot run because the volume is in use by another
process. Would you like to schedule this volume to be
checked the next time the system restarts? (Y/N)

Type: Y

Reboot as needed.


Then run:

​

Post a share link.



5) These steps can run overnight while sleeping:

a) Sea Tools Long Generic test
b) HD Tune Full error scan
c) chkdsk /b /v



6) The installed RAM (CMG32GX4M2D3600C18) were not seen on the Qualified Vendor List (QVL).
What step had been to check or assure compatibility?